Sentinel 717 Thickened Mastic Remover Gel
717 Thickened Mastic Remover Gel is designed to remove tile mastics and carpet adhesives from cracked and degraded surfaces, and multiple level buildings, reducing the chance of mastic and remover leaking through subfloors. Its viscosity enables it to cling to vertical surfaces, allowing the product to remove mastics from walls and stairs. V.O.C. COMPLIANT
This product is designed to clean and remove black asphalt, solvent based mastics and clear thin spread adhesives commonly found under 9” and 12” vinyl floor tile.
Physical State: Liquid
Appearance: Clear
Color: None to Amber
Odor: Mild Solvent Odor
pH: Not applicable
Flash Point: >145°F
Boiling Point: 400-470°F
Self-Ignition Temp: 421°F
Vapor Pressure: <0.5 mm Hg@68°F
V.O.C. Content: <50 g/L (calc.)*
Shelf Life: 48 Months
Coverage Rate: 50-100 sq. ft./gal
Available in 5 Gal Pails (48/Pallet) or 55 Gal Drums (4/Pallet)
This product works best at room temperature (70°F). Colder temperatures can affect product performance. Protect walls, cabinetry, trim, drains, cracks and adjoining flooring with plastic and/or absorbent dikes (oil absorbing powder, kitty litter, rags) to keep mastic remover and liquefied adhesive contained as well as to protect from overspray or agitated material in subsequent steps.
DIRECTIONS:
Before beginning work, protect all walls, flooring, carpeting, cracks or wood with an absorbent from liquid materials. This will ensure easier clean-up and eliminate potential problems
STEP 1: Wet the entire adhesive surface with before reflooring. product. This may be done by pouring the 717 directly to the floor and using a mop or floor squeegee to move it over the surface of the adhesive. DO NOT overapply. Allow 717 to soak and penetrate for 45 - 60 minutes
STEP 2: Scrape the bulk of the softened adhesive from the surface with a floor scraper. This will help increase the coverage of 717 and reduce the amount of liquid generated and make final clean up easier. Place in a container for disposal
STEP 3: Reapply 717 as in Step One. To fully lift and liquify adhesive residue from the floor agitate with a short-bristled broom, handheld or rotating floor scrubber with stripper pads. Squeegee resulting mixture into puddles and solidify with an absorbent. Remove absorbed material to a container and dispose. Follow all local, state and federal regulations when disposing of waste.
STEP 4: Wash and rinse the floor thoroughly with a degreaser and water to ensure a clean surface. Allow to dry a minimum of 24 hours before installing new flooring.
Expect coverage rates of 50-100 sq. feet per gallon.
This Floor or Wall Covering Adhesive Remover contains less than 5% V.O.C. content by weight, in accordance with the requirements set forth by the California Air Resource Board (CARB) and Ozone Transport Commission (OTC), effective 1-1-2009.
Seller makes no warranty, expressed or implied, nor accepts any responsibility for any direct or consequential damages beyond purchase price, because seller cannot control users handling and use or effect of that use.
Save 5% when you buy a pallet - contact us for a quote larger quantities
