Sentinel 7200 No Odor Mastic High Flash Remover
7200 No Odor Mastic Remover is formulated with a flashpoint greater than 200˚ F and is designed to clean and remove black asphalt and solvent based mastics in odor sensitive areas such as schools, high rises, hospitals, government and residential buildings. V.O.C. COMPLIANT
This product is designed to clean and remove black asphalt, solvent based mastics and clear thin spread adhesives commonly found under 9” and 12” vinyl floor tile.
Physical State: Liquid
Appearance: Clear
Color: None to Amber
Odor: Mild Solvent Odor
pH: Not applicable
Flash Point: >200°F
Boiling Point: 363 - 381°F
Self-Ignition Temp: 421°F
Vapor Pressure: <0.55 mm Hg@68°F
V.O.C. Content: <15 g/L (calc.)*
Shelf Life: 60 Months
Coverage Rate: 100 -200 sq. ft./gal
Available in 5 Gal Pails (48/Pallet) or 55 Gal Drums (4/Pallet)
This product works best at room temperature (70°F). Colder temperatures can affect product performance. Protect walls, cabinetry, trim, drains, cracks and adjoining flooring with plastic and/or absorbent dikes (oil absorbing powder, kitty litter, rags) to keep mastic remover and liquefied adhesive contained as well as to protect from overspray or agitated material in subsequent steps.
DIRECTIONS:
Before beginning work, protect all walls, flooring, carpeting, cracks or wood with an absorbent from liquid materials. This will ensure easier clean-up and eliminate potential problems
STEP 1: Wet the entire adhesive surface with 7200. This may be done by spraying or mopping 7200 over the surface of the mastic. Allow 7200 to soak and penetrate into the mastic for 10 – 20 minutes.
STEP 2: Scrape or squeegee the bulk of the softened or liquefied mastic from the surface with a floor scraper (razor scraper) or floor squeegee.
STEP 3: Reapply 7200 as in step one. Agitate with a short-bristled broom, hand-held or rotating floor scrubber with stripper pads to fully lift and liquefy adhesive residue from the subfloor. The liquid may then removed with absorbent.
STEP 4: Wash and rinse the floor thoroughly with a degreaser and water to ensure a clean surface. Allow to dry a minimum of 24 hours before installing new flooring.
Expect coverage rates of 100-200 sq. feet per gallon.
This Floor or Wall Covering Adhesive Remover contains less than 5% V.O.C. content by weight, in accordance with the requirements set forth by the California Air Resource Board (CARB) and Ozone Transport Commission (OTC), effective 1-1-2009.
Seller makes no warranty, expressed or implied, nor accepts any responsibility for any direct or consequential damages beyond purchase price, because seller cannot control users handling and use or effect of that use.
Save 5% when you buy a pallet - contact us for a quote larger quantities
